Back to the legs.
You will need the leg straps you made before and this piece (you need 2 of them) and you need to cut slits where I marked on the pattern...
Where you have sewn the strips together at the top of you thigh is where this piece needs to go. The cross should be in the centre of the piece then sew it.
However! Only sew in the shaded areas shown below, as if you sew in other areas the stitching will be visible but if you sew only in the shaded areas then you wont see the stitching as they are going to be covered and it will look much smoother.
Once that is done we can make the straps that wrap around your legs.
Cut another strip of 140cm x 2cm.
Sew a buckle onto the end (Using the first method that we used for the top part of the harness) and thread the other end through the piece on these of your leg and then the buckle and pull until tight. Cut a hole for the spike and cut off the excess fabric, then use the leftover fabric to repeat the step another 3 times as you need 2 per leg, a total of 4!
The same steps for both legs! Comment any questions.
No comments:
Post a Comment